|
|
| Author |
Message |
EnjoyMF
Active User
Joined: 27 May 2005
Posts: 92
|
|
|
|
Hi guys
I always get S522 error as time out error
Can some one tell me when we get S522 error
Regards
Prasad |
|
| Back to top |
|
 |
References
|
 Posted: Thu Jan 19, 2006 6:22 pm Post subject: Re: When we get S522 error |
|
|
|
|
MGIndaco
Moderator
Joined: 10 Mar 2005
Posts: 479
Location: Milan, Italy
|
|
|
|
Try to install Abend Assist v1.0 
Reason:
| Quote: |
| All of the tasks in a job step were in an SVC wait state for the time specified in the JWT parameter in the SMFPRMxx parmlib member. The event control block (ECB) specified in the wait request was never posted. This could be the result of waiting on the wrong ECB or not posting the correct ECB |
User Response:
| Quote: |
| Correct any errors and execute the job step again. If no errors are found and the wait is expected for that particular job step, specify TIME=NOLIMIT in the EXEC statement to bypass all job step timing. |
Hope in this.  |
|
| Back to top |
|
|
Bitneuker
IMS Moderator
Joined: 07 Nov 2005
Posts: 1130
Location: The Netherlands at Hole 19
|
|
|
|
Hi Mainframe enjoyer,
IMHO S522 stands for too long waiting for mounting a required device like tape or disk.
Cheers, |
|
| Back to top |
|
|
mcmillan
Site Admin
Joined: 18 May 2003
Posts: 888
Location: India
|
|
| Back to top |
|
|
Bitneuker
IMS Moderator
Joined: 07 Nov 2005
Posts: 1130
Location: The Netherlands at Hole 19
|
|
|
|
mcmillan,
You're right: just tried to give an example of a possible reason this SVC was waiting.
Cheers, |
|
| Back to top |
|
|
|
|
