i am bit confused with my spool settings. i need to enter the tso sdsf command everytime from my ispf panel to enter the spool where i could see my jobs. i cannot swap between the working screens and spool and no action bar avaialbe from there. when i try the general sdsf;st comand the spool gets displayed but the job that were submitted by me.. or anyone .. wont get displayed.. i tried all the commands but none were working . i feel there is some problem with my spool settings .could anyone have idea about this. this could be of gud help to me
SDSF has both an ISPF and non-ISPF interface. typing TSO SDSF gets the non-ISPF one. Check with your system support to see if there is a menu option or command table entry. A command table entry means you can enter the command anywhere within ISPF.
thanks for all the replies. i id was revoked so i could not try what u guys told earlier, but when i did it is still not working with pre option, dest=local can u guys give me some more information or ideas so that it will work