View previous topic :: View next topic
|
Author |
Message |
vpr_118 Warnings : 1 New User
Joined: 07 Apr 2008 Posts: 64 Location: chennai
|
|
|
|
Hi I am using K9801GCP utility to create a parm which later can be usaed as coontrol card..
But i am getting the error
DSS20006E - MEMBER 'K9801GCP' WAS NOT FOUND
let me the library for K9801GCP |
|
Back to top |
|
|
Gnanas N
Active Member
Joined: 06 Sep 2007 Posts: 792 Location: Chennai, India
|
|
|
|
The member 'K9801GCP' does not exist in this data set. It may have been deleted by
a previous step or JOB, or it may have been misspelled. If this is a PGM=,
then the program cannot be found in the LPA, LINKLIST, or a STEPLIB or
JOBLIB. |
|
Back to top |
|
|
enrico-sorichetti
Superior Member
Joined: 14 Mar 2007 Posts: 10873 Location: italy
|
|
|
|
the program is shop specific
ask Your peers or Your support about it...
- how to use it
- where it is located
( looks like some library is missing from Your concatenations ) |
|
Back to top |
|
|
dick scherrer
Moderator Emeritus
Joined: 23 Nov 2006 Posts: 19244 Location: Inside the Matrix
|
|
|
|
Hello,
Quote: |
I am using K9801GCP utility |
Why are you using this utility? How did you come to know of it?
Quote: |
let me the library for K9801GCP |
Unless some member of the forum is one of your co-workers, no one here will likely know the name of the dataset on your system.
You have either set the jcl up incorrectly or have mis-spelled something.
If you post the jcl from the problem step, we can probably tell you what the problem is, but probably not the specific solution.
Someone on your system will know the answer. |
|
Back to top |
|
|
|